[2622] More Prototype PC Boards

Date: August 23rd, 2019 | Comments : none | Categories: DIY.

Just got a new package from OSHpark with some prototype pc boards. Besides the Squeezer compressor, there is a new op amp fuzz and 3 sets of mini-boards, one of which is a tiny mini-booster. More info soon.


[2617] ADV-Snare pcb

Date: August 23rd, 2019 | Comments : [3] | Categories: DIY.

While looking through some boxes of old material, I came across this completed pcb for the ADV-Snare project that I designed with Thomas Henry. The article on this project was published in Nuts-and-Volts magazine over 20 years ago!


[2607] Low Input Impedance Fuzz

Date: August 16th, 2019 | Comments : none | Categories: DIY.

Low input impedance is not really the issue making a fuzz incompatible with a buffer.

A fuzz face has a lot of gain…. VERY high. It is basically a crude inverting op amp with a 100k resistor in the negative feedback loop. There is no resistor in series with the audio input that would otherwise reduce the gain. The simplified gain equation is Rf/Ri where Rf is the feedback resistance (100k) and Ri is the input resistance. When connected directly to a guitar, the combined resistance and impedance of the pickups are in series with the input (acting as Ri) and will reduce the gain, thereby preventing the fuzz from going bonkers.

If you drive the fuzz with a buffer, the output resistance/impedance of the buffer is very low so the result is that the fuzz circuit runs at max gain with oscillations and other mayhem often as the result. Buffered input = max gain = bonkers, and guitar pickup = lower gain = fuzz heaven ­čÖé

The Rangemaster does not have this problem because the available gain from the Ge transistor is much lower than that available from a FF.

The Big Muff does not have this problem because each gain stage has a series resistor to reduce their gain… 39k on the input stage, for example.


[2604] How Charge Pumps Work

Date: August 9th, 2019 | Comments : [2] | Categories: DIY.

Charge pumps are fairly simple devices. They involve charging a capacitor to the voltage of the supply, and then stacking it on top of that power supply so that the voltage potentials are added together, effectively doubling the output.


[2599] Bodge wire

Date: August 1st, 2019 | Comments : [2] | Categories: DIY.

It looks like the pcb on this Daphon E20CM compressor was supposed to have a square cutout in the top left corner to match the one on the right side, in order to fit around the mounting post. When cutting the pcb, the board fractured and chipped off a small piece including a portion of a copper trace. Instead of trashing the damaged board, they added a bodge wire to replace the missing trace.



AMZ Home Page

Guitar FX PCBs