I had to open up the new MXR Rockman X100 to move the output switch over to stereo, so I took a picture of the pcb while I had it open.
It looks to be very well done, with only a couple of minor glitches. The switch pcb on my pedal is quite crooked, and the soldering on the MN3007 delay chip is not the best. It also looks like someone has taken a cotton bud with some alcohol, and removed the ink from all of the chips. It makes it hard to read the numbers but not impossible. I could see a pair of TL074 quad op amps, a TL072, the MN3007 and an LM317L voltage regulator. There are more but I did not take the time to try to identify them all
Thumbs up to MXR for making this classic design available again!
